Skip to content
OCRVEmpire

Electrical and Systems

RV Cooktop, Range, Oven and Microwave Replacement

Typical range

$350 to $2,500

Shop hours

1 to 10

Labor rate

$260/hr

The short answer

Galley appliance work covers LP cooktop and range replacement, oven igniter and thermostat repair, microwave and convection unit swaps, and the cabinet and gas connection work each requires. Runs $350 to $2,500, or 1 to 10 hours at $260 per hour plus appliances.

01

What this work actually involves

Range and cooktop work is mostly gas work with a cabinet problem attached. Every LP appliance connection has to be made by a certified technician and pressure tested afterward, and the cutout in a coach galley almost never matches the new appliance exactly. Manufacturers change dimensions between model years, so a replacement cooktop usually means modifying the countertop opening, refitting trim, and often relocating the gas stub. The appliance cost is frequently the smaller half of the job.

The common repairs are simpler than owners expect. Burners with a lazy yellow flame are usually partially blocked orifices or spiders in the venturi tubes, which is a genuine problem in Southern California where mud daubers colonize anything that sits for a season. Ovens that light and go out are almost always a failing thermocouple or a dirty flame sensor, not a bad valve. And an oven that runs 75 degrees off is a thermostat calibration issue, not a reason to replace an otherwise sound range.

Microwaves and convection units are electrical rather than gas, and the failure mode that matters is the mounting. A microwave mounted to a cabinet face with the original fasteners after a remodel can tear out on a rough freeway, and a convection unit draws enough current that it needs a properly sized circuit rather than sharing a galley outlet. We mount into framing, check the circuit capacity, and verify the vent path on over-range units so the hood actually discharges outside instead of into a cabinet.

Systems and brands we work on: Suburban, Atwood, Dometic, Furrion.

Location: All work is performed at our Yorba Linda facility. We do not offer mobile, roadside, or fleet route service.

02

What the job includes

  • LP cooktop, range, and oven replacement with certified gas connection
  • Countertop cutout modification and trim fitting for a different footprint
  • Gas stub relocation and shutoff valve replacement at the appliance
  • Burner orifice cleaning and venturi tube clearing of spider and wasp nests
  • Oven igniter, thermocouple, safety valve, and thermostat calibration
  • Microwave and convection microwave replacement and structural mounting
  • Dedicated circuit verification and upgrade for high draw convection units
  • Range hood vent path correction so exhaust discharges outside
  • Induction and 120V cooktop conversion with load planning
  • Documented pressure test of the gas system after every connection

03

When you need this service

  • Burner flame that is yellow, lazy, or lifting off the burner head
  • Oven that lights and then goes out after a few minutes
  • Oven temperature far off from the dial setting
  • A gas smell at the range when a burner is turned on
  • Microwave that is loose in its opening or sagging at the mount
  • Convection unit tripping a breaker when it runs at full power

04

How we do it, step by step

  1. 01

    Appliance identification and fit check

    Existing cutout, gas stub location, and clearances measured against the replacement before ordering, because model year dimension changes cause most of the cabinet work.

  2. 02

    Diagnose before replacing

    On repair calls we check orifices, venturi tubes, thermocouples, and thermostat calibration first. Many ranges written off as failed are a cleaning and a $40 part.

  3. 03

    Cabinet and countertop work

    Opening modified, framing reinforced where needed, and trim fitted so the finished install looks like it belongs rather than like a part swap.

  4. 04

    Certified gas connection

    All LP connections made by certified technicians with correct flare fittings and thread compound, and a shutoff valve at the appliance verified for function.

  5. 05

    Electrical and venting

    Circuit capacity confirmed for microwave and convection loads, mounting fastened into framing, and the range hood vent path traced to an actual exterior discharge.

  6. 06

    Pressure test and function check

    Documented system pressure test after any gas connection, then every burner, the oven, and the microwave run through a full function check before delivery.

05

Pricing and posted rates

Pricing for Cooktop, Range and Microwave Replacement
ItemRate or rangeNotes
Typical job range$350 to $2,500Varies with extent of damage and parts availability
Shop hours1 to 10Quoted after teardown, not before
Mechanical and electrical labor$260 per hour2026 posted rate
Parts100% markup under $100, 35% overSpecial order parts require a non refundable deposit at order
Deposit50% at authorization over $2,000Additional 25% when parts arrive on jobs over $10,000
Sales tax7.75% on parts and materialsLabor is not taxed

Insurance billed jobs may be billed at carrier negotiated labor rates that differ from the posted retail rates above. See all posted rates.

07

Vehicles we do this work on

08

Questions about cooktop, range and microwave replacement

Frequently asked questions

How much does an RV cooktop or range replacement cost?

Work runs $350 to $2,500, or 1 to 10 hours at $260 per hour plus the appliance. A drop-in cooktop that matches the existing cutout is at the low end. A full range replacement requiring countertop modification, gas stub relocation, new trim, and a documented pressure test is at the high end.

Why are my burners burning yellow instead of blue?

Usually a partially blocked orifice or a spider web in the venturi tube restricting air mixing. Mud daubers and spiders colonize RV appliances that sit through a Southern California season, and the galley range is a favorite. It can also indicate low delivered LP pressure, which we measure at the appliance before cleaning anything.

My oven lights and then goes out. What is failing?

Nearly always the thermocouple or flame sensing device. It has to stay hot enough to hold the safety valve open, and as it ages it loses output and the valve closes. It is an inexpensive part. Replacing the whole range for that symptom is one of the more common unnecessary expenses we see owners talked into.

Who makes the gas connections?

Certified technicians only, and every gas connection is followed by a documented system pressure test recorded on the invoice. All of it is performed in the shop at our Yorba Linda facility. We do not make LP connections outside the building and we do not let general technicians work on gas.

Can I switch from propane to induction cooking?

Yes, and it is increasingly popular on lithium equipped builds. The requirement is electrical capacity. A single induction burner needs roughly 1,500 to 1,800 watts, which means a real inverter and a bank that can support it. We calculate the load against your system honestly before recommending it, since it is a poor fit on a small bank.

09

Related services

10

More electrical and systems work

Ready to move on cooktop, range and microwave replacement? Bring it to Yorba Linda.